Questions? Feedback? powered by Olark live chat software

MOVIT PRODDER MAXI - Step Power - 800mm Reach Spring Steel Shaft + Extra 550mm Wand

USD 166.45
(No reviews yet) Write a Review
SKU:
CAT 45C55
Condition:
New
Availability:
Dispatched within 24 Hours
Shipping:
Calculated at Checkout
MOVIT PRODDER MAXI - Step Power - 800mm Reach Spring Steel Shaft + Extra 550mm Wand

MOVIT Cattle Prod Maxi - Step Power - 800mm Reach + Extra 550mm Wand

Step Power: Electrical current ‘steps up’ from zero to maximum in 2 seconds. 
 
cat-45c8a-size.jpg 
Hassle-free driving
Reduces risk of bleeding and dead animals
Better yield and meat quality – less stress
Strong wand from durable almost indestructible aluminium and spring steel
Balanced weight, no moving parts - solid drive electronics
 
  cat-45p8.jpg
 
MOVIT PRODDER MAXI takes 4x size D alkaline batteries - included*
*batteries not included for shipments outside Australia due to air freight regulations
 
Output voltage a massive 8,000 to 10,000 volts whilst still maintaining a respectable 550 ma battery current draw. Using good quality batteries, batteries will last 18 days continuous use (2 seconds on 20 seconds off – 8 hours / day).
 
The cattle prod is intended to stimulate animals to move in stockyards and similar surrounds. 
Any other use is not intended and bears safety risks, MEFE disclaims any liability whatsoever for any damages caused. 
This cattle prod is state-of-the-art and complies with health and safety requirements issued by the EU, however it presents hazards which cannot be eliminated and should be used with extreme care. The unit is a capacitor discharge system and has a memory effect; the probes may remain charged after use.
 
Important Safety Notice:
Use on animals only – never use on humans.
Keep out of reach of children
Do not submerge in liquid – keep probes clean and dry
 
Operating Instructions:
Use only on animals – operation on humans could result in serious injury and even death.
Recommend the use of 4x alkaline batteries size “D”, install into back cap and replace when spark is weak.
Secure the wand to handle with locating notch – see assembly instructions.
When shorted out and the button is pressed, a sparking will be heard inside the unit – this is normal (this may occur when prodding wet animals). Proceed with caution - potential increase of intensity..
Ensure back cap and wand collar is secure.
 
To achieve less stressed animals, apply the probe to the animal before pressing the button. After probe has made contact, press and hold the button. The animal will move when discomfort level reached, avoid undue stress and observe in case the animal may be sick or injured.
 
Shipping Notice:
Please allow a possible additional 2 weeks for deliveries outside Australia due to customs clearance in receiving country.